GeeBat nRF24L01+ 2.4GHz Antenna Wireless Transceiver RF Transceiver Module Arduino Raspberry Pi Compatible Pack of 10pcs

Related posts

Feature

nRF24L01 is a single chip radio transceiver for the worldwide 2.4 - 2.5 GHz ISM band. It's Arduino and Raspberry Pi compatible.
The transceiver consists of a fully integrated frequency synthesizer, a power amplifier, a crystal oscillator, a demodulator, modulator and enhanced Shock-burst, protocol engine.
A host micro-controller can communicate and configure the nRF24L01+ over a 4-pin Serial Peripheral Interface (SPI). The configuration registers are accessible through the SPI connection.
Internal filtering results in high margins of meeting RF regulatory standards. The module's radio uses Gaussian Frequency-Shift Keying (GFSK) modulation as well as fast Automatic Gain Control (AGC).
Applications: wireless peripherals, remote control systems such as RC vehicles and consumer remote electronics, wireless voice transmission such as VoIP, wireless sensor networks, wireless networks, home and commercial automation.

Description

Specifications:
Ultra small: 15x29mm (including: built-in 2.4GHz antenna),for easy implementation into designs without additional hardware.
Low power consumption: Ultra low power consumption as low as 11.3mA transmitting, 13.5mA receiving at 2Mbps, 900nA in power down, and 26uA in standby.
Low operating voltage: 1.9 ~ 3.6V When using the nRF24L01 with an Arduino be sure to use the 3.3V output pin from the Arduino board to power the nRF24L01+ module.
Communication range: 262 feet (80 meters) in ideal conditions.
Multi-channel: support six channels data reception.
Fast data transfer rate: 2Mbps (software setting range: 1Mbps or 2Mbps).
Multi frequency points: 125 frequency points to meet the needs of multi point communication and frequency hopping communication.
The maximum transmit power: 0dBm.


Product Contents:
10 pieces Addicore nRF24L01+ modules